| site home | document home |

Purpose Section

The purpose of this procedure is to provide general instructions for the calibration of ring gages.

Another Sample Section (Specifications)

The specifications of the IUT are determined by the applicable manufacturer's documentation. If the manufacturer's documentation is not available, then the specifications identified in this procedure are used.

The following are "nominal diameters" and tolerances for ring sizes up to 8 inches.

Nominal Diameter Tolerance

• Up to 0.500 Inches 25 Microinches
• 0.5001 to 4.000 Inches 50 Microinches
• 4.0001 to 8.000 Inches 100 Microinches
• Up to 0.500 Inches 25 Microinches
• 0.5001 and Larger 100 Microinches

Screen Shot